What is difference between Pipe and Tube?
Answer Posted / chkr
vikas ans. in correct.
Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
differentiate between total moisture and inherent moisture of coal.
Define a process flow diagram?
State newton’s law of convection.
When a 30KW/3 ph pump runs one hour continously, what will be the heat dissipated? how can i find this, any general equation?
why the reaction turbines are not exposed to atmosphere? and why the impulse turbines are exposed to?
What is screw,centrifugal and rotary type compressors,how it works and what is principle .
Why is stress considered important in a shaft?
What are reasons for poor machinability for IS 2062 steel
Discuss various surface finishing processes?
What is the difference between projectile motion and a rocket motion?
sir i appeared to bosch written test recently and i cleared it successfully.can u suggest me how the interview will be done ?is it technical or HR or both?how shall i prepare for it?i am very eager to work with and in fact it is my dream job suggest me how to grab the job.if you know tell what type books are prefer for preparation of intrview?
My vendor filled liquid oxygen in our 11000 liter capacity tank. He filled from 1400 MMWC up to 3200 MMWC. I followed the provided conversion table and found that we had been supplied 1800 MMWC liquid which is going to yield 2815 cubic meter. On the other hand, the vendor claims that he supplied as follows:- 5236 cub mtr(3200 MMWC)-2124 cub mtr(1400MMWC) = 3112 cub mtr. I fear that he wants to charge 297 cubic meters extra. He claims that my method was wrong and his was right. He says that this disparity is because of the conical shape of the base of the flask. I will be thankful if somebody can explain me the truth.
Steering handle (round dial) of motor vehicles (CAR,BUS,LORRY) wiil be designing with two cross supports without 180 degree straightness( it will be little bit cross). Why?
Cox chart is used in ....Distillation, evaporation, drying
which type of material is F125?