Answer / nirmalya basu

Generally ammeter has internal resistance lower than the
load resistance so if we connect the ammeter in series with
load so maximum current flows through the ammeter so we can
get current value.
on the other hand voltmeter's internal resistance is very
much higher than load resistance, so if we connect
voltmeter in parallel with load then a minimum but constant
current can flow through the voltmeter by calculating the
voltage we can calculate the actual drop.

Why Flow measurement has to use Square Root

5 Answers   Hindalco, Petronas,

---

can i use 1 sq mm insted of 1.5 sqmm cable cable length 600 mts under ground laying Cable carrying 24 vdc 4-20ma current

2 Answers  

---

How to check vortex flow meter is in good condition while we do not having calibration setup?

4 Answers  

---

what are the possible reasons if a control valve fails to open/close?

1 Answers   DEWA,

---

What is the Working principle of Dozing valve?

0 Answers   Shree Cement,

---

what is function of DCS , and how is it work , explain with difination

1 Answers   Bapco Bahrain Petroleum Company,

---

Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.

0 Answers   Honeywell, Tata Steel Limited,

---

which one is best profibus or RS485 for communication?

2 Answers   Honeywell,

---

hydrogen purity meter calibrating and commissioning procedure can be explained?

1 Answers  

---

Dear Sir/Madam, I am attending an interview for ETs in BHEL. I have cleared my written test under Electronics (Instrumentation). This is the first time I am appearing for an interview. Can any one who has attended the interview earlier give me a clue to face the interview. With regards Sindhu

2 Answers   Siemens,

---

what is the difference between -24 : +24 & 0:24 and where it use?

0 Answers  

---

what is electric motorised valve working principle.

1 Answers  

---