when we calibrate the DP transmitter at that time which matrial we used in pre

when we calibrate the DP transmitter at that time which
matrial we used in pressure pump?

Question Posted / mayur.kevadiya

4 Answers
7366 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

when we calibrate the DP transmitter at that time which matrial we used in pressure pump?..

Answer / divyesh

if pressure pump is hydrolic then oil or water is used and
if pressure pump is penumetic teen only air.

Is This Answer Correct ?

6 Yes

0 No

when we calibrate the DP transmitter at that time which matrial we used in pressure pump?..

Answer / naeemsuleman

hydraulic oil in dead weight tester.

Is This Answer Correct ?

2 Yes

2 No

when we calibrate the DP transmitter at that time which matrial we used in pressure pump?..

Answer / abhishek vyas

As DP having a very low pressure range so niether dead
weight nor water is used you can simply use air it will
provide you correct calibration.

Is This Answer Correct ?

1 Yes

1 No

when we calibrate the DP transmitter at that time which matrial we used in pressure pump?..

Answer / rohan

dead weight tester

Is This Answer Correct ?

2 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

what is effect of specific gravity in differential level transmitter , explain formula related with this .

0 Answers Flour Tech Engineers (P) Ltd,

which is the best type to measure level of a Tank(water). Displacer or Differential Pressure method?

2 Answers

What is open loop checking and close loop checking

1 Answers BARC, NTPC,

can someone tell me about electronic speed switch &how it conect with proximittyswitch?(with dgm)

0 Answers

Dead weight tester & comparator for calibration , which is more accurate , what is the application.

1 Answers Bapco Bahrain Petroleum Company,

how to control motor load with rpm or vfd

1 Answers

Decibel.

0 Answers CCIE,

i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?

2 Answers

We have ZR22G-100-S-A-E-T-T--E-A/CV/F1 Model Zirconia Oxygen analyser which is Yokogawa make. I kept the analyser in Flue gas path at Air pre heater area. My plant is 7.5MW Biomass power plant. For a particular fuel, Coconut Husk which contains Sodium and Potassium chlorides iam not getting proper reading, Analyser output always Zero. I calibrated the analyser and it is OK. For Other fuels like Wood chips, Cholam waste, DOB, Groundnutshells, Ply wood waste and all iam getting actual percentage of Oxygen. What is the main reason behind this draw back?

2 Answers

Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?

0 Answers

plz give me the logic for how a pushbuttoon can be worked as atoggle switch i m working with allenbradely/micrologix1200/rslogix500

3 Answers

Single acting ON-OFF valve. it is air to open. when sov energized , valve will be open, so during that if air fail then what will be the condition of valve ( open or close ) ???

4 Answers

For more Instrumentation Interview Questions Click Here