in thermal power plant the steam produced is made to cool after falling on the

in thermal power plant the steam produced is made to cool
after falling on the turbine blades.
my question is why this is done while the same is needed to
heat up again.
"jab pani ko wapis garam hi karna hai to thanda kyu karte
hai"

Question Posted / ghanshyam singh

11 Answers
17594 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

in thermal power plant the steam produced is made to cool after falling on the turbine blades. my..

Answer / chandrahasan

in this cyclic process, cooling is needed to convert water
from hot steam. This water is again reheated to convert hot
and high pressure steam.

Is This Answer Correct ?

1 Yes

5 No

Post New Answer

More Electrical Engineering Interview Questions

which type of amplifiers are used in multimete?

0 Answers NTPC,

WHAT IS A DIFFERENCE BETWEEN A DC GEAR MOTOR AND STEPPER MOTOR.AND WHICH IS MORE APPROPRIATE TO USE FOR POSITION CONTROL PURPOSE?

1 Answers

what is the first step of dg shycroning ?

2 Answers ABB,

my question is that....few days ago i had installed a three phase motor starter for an electric saw.the motor will run and make the hydraulic pressure which will be goes to pressure cylender by up and down lever.two number of limitswitches are also installed on cylinder for safety of motor.now when the arm of cylinder reaches to the upper or lower limit it will cut the motor's line.and motor will be stop.now wana know that what will i do that motor runs continue after the limitswitch cut it down but it shold not be made any pressure.pls answer me in brief.

3 Answers

What are the different auxiliary protections of a transformer?

1 Answers CESC,

There is 3phase power cable from 1 point to the other point which is 100m away. Two point equipped with power meter and recorded 1st point is 205kW while the 2nd is 202kW and each phase average carry 400amps. To calculate the resistance of the 3phase power cable, is the formula using will be P=I2R?

3 Answers

What are Line losses and how can be it minimized/controlled.?

2 Answers Omega, XYZ,

What is the function of the generator exciter?

0 Answers

How to calculate earth flat size for 250 Kva DG and transformer?

8 Answers Deepak Fertilisers,

what happan when ac power transmitted in unity power factor

12 Answers JE, Maihar Cement,

slor cell made?

1 Answers

CAN ANYBODY PL TELL ME WAT FACTORS CAN CAUSE UNDERVOLTAGE ON A BUS??? PL LIST ALL THE REASONS WITH SOME EXPLAINATION