What are Sinking and Sourcing IO Cards
Answers were Sorted based on User's Feedback
Answer / nirmalyabasu
If the power is comming through the i/p or o/p device to
the io card then that i/o card is called sinking i/o card.
And if the power is transfered from io card to the i/p and
o/p devices then the i/o card is called sourceing io card
Is This Answer Correct ? | 12 Yes | 1 No |
Answer / mun
sinking and sourcing is regards the current flow
so if the power from the card is called sourcing
if the power from out side the card coming to it called
sinking
Is This Answer Correct ? | 1 Yes | 1 No |
How much should be the values and/or percentages of these given below factors for a good controller ? Steady state error Delay Rise Time Overshoot Peak Time Settling Time Damping Oscillations & vibrations thanks
How the sizing of the analog signal cable is calculate?
selection criteria of control valve? and selection criteria of actuator explain in brief?
What is the relationship between the universal gravitational constant (G) and the acceleration due to gravity (g)?
Why flow/pressure transmitter before control valve?
How can one improve linearity of an RTD based temperature measurement system?
Absolute pressure is 700psi,what will be the gauge pressure?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
0 Answers Adgas, GAIL, Oil India, ONGC,
Q- voltage source of 12v is driving the circuit.if circut draw the current of 0.5A them source voltage will became 11.8v.what is the power dilevered by source when circuit draw 5A current ?
what should be minimum length and size of impulse line for steam flow orifice and feed water orifice? asked by sanjay parihar
What is meant by GAP VOLTAGE, in vibration measurement. Normally how much GAP VOLTAGE is set and state the reason.
i have one absolute pressure transmitter for the range is -400mmhg to 400mmhg. If i do the zero trim at atmosphere the transmitter should be give 4ma or 12ma? which one is correct?