Answer / Sudheer Kumar

"Try work calculation is a method used in instrumentation for calculating the amount of work done by an electric current as it passes through an electrolyte. The formula for try work (W) is W = ItE, where I is the current in amperes, t is time in seconds, and E is the electromotive force in volts."

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

1 Answers   TNPL,

---

what is mean by hot loop and cold loop testing, whts different between both

2 Answers   Honeywell, PDO,

---

Example of dry contacts & wet contacts?

3 Answers  

---

why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

1 Answers   Hospira,

---

How do you troubleshoot accelerometers used in Vibration monitoring/tripping

1 Answers   Air Liquide,

---

What is Square Root Extractor for?

9 Answers   Sabic,

---

In instrumentation standard we use 4 to 20ma for transmission , why cant we use 3 to 19ma ?

1 Answers   NSH,

---

why fuse block is not used for AI signal?

1 Answers  

---

which one is best profibus or RS485 for communication?

2 Answers   Honeywell,

---

The wire is disconnected from the temperature sending unit (magnetic gauge). A voltmeter connected to the wire reads 0v. What does this indicate?

2 Answers  

---

give some question relative instrument fitter?

1 Answers   Armco,

---

what is the difference b/w normal thermocouple and skin type thermocouple?

1 Answers   Heisco,

---