Answer / jits_patel2002

you Question is not correct...... I think you want to used PLC system for hazardous ares application. 

Can you please give more details about it?

Answer / pappu

Yes you may use it with reasonable restrictions. But very important: there is no absolute freedom. You must check the PLC by reading the specification document. Read the restrictions under section 66A also. Only then you know what you cannot and should not do with it. It is always better to be safe than sorry. So avoid problems, as it is also called "chilling effect" from legal point of view. When you get this thought the next time say "chill it"!

1 > HOW TO MEASURE INTERFACE LEVEL 2 > DIFFERENCE BETWEEN RADAR & ULTRASONIC LEVEL TRANSMITTER

3 Answers   Atul Auto,

---

Explain about the leakage class of the control valves

0 Answers   CCIE,

---

If an Instrument has 550 ohm internal resistance and the cable used for that instrument is 0.5 ohm per meter resistance. If the voltage is 12volt.How much length cable can be used? Please tell me its Calculation formula.

5 Answers   MOL,

---

how flame detectors sense the flame.

3 Answers  

---

i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in

0 Answers  

---

what is meant by calibration

3 Answers  

---

Which Signal hart communicator work? If there any signal change when hart connect while transmitter in line ?

0 Answers   KOC,

---

model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com

0 Answers   Jindal,

---

what is loop folder?

1 Answers   Bapco Bahrain Petroleum Company, Hyundai,

---

please explain about actuator action? direct action & return action ?

1 Answers  

---

Why shield is not connected at both end.

5 Answers  

---

i have steam drum height 1000mm. and i want to placed the transmitter below the tap.how i calculate.

0 Answers   OEG,

---