what are the industrail measures to overcome ferranti
effect? how would the ferranti effect the power system if
those remedial mearsure arent taken? how often does this
effect occurs in real power system? plz reply
Answers were Sorted based on User's Feedback
Answer / sakthivel
ALL WAYS REACTOR ARE CONNECTED IN SERIES IN TRANSMISSION
LINE IN POWER SYSTEM
| Is This Answer Correct ? | 2 Yes | 0 No |
Answer / atif rasheed khan
shunt reactors of suitable rating according to supply
voltage should be connected, which will overcome the
ferranti effect.
the effect of ferranti effect at the power system is that it
over loads the system which is not not suitable for
reliability of power system.
the ferranti effect does occurs when there is a supply of
high power to one particular point,and light loads are
connected to that point.
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / ranjeet kumar suman
shunt reactor be used to overcome ferranti effect.due to tis
effect the reciving end voltage be greater than sending end
during light load condition....
| Is This Answer Correct ? | 0 Yes | 5 No |
an ac induction motor gets overheated when operated at a low frequency of 25 hz a instead of 50 hz. reason?
What we change frequency from transformer. yes or no
What is communication? What are the different stagesin the communication process?
Why in celling fan stator are rotatig while rotor are steday
A motor works on 30kw.it is working on 440volts.How much amper will be Required?
what happen if the battery is charged by more than one source ,for ex: connecting data cable to laptop & charger pin to source supply ?
write a program that prints prime numbers from 1-20 in digonal form
how to set earth fault relay
sir What is the different bet'n "Active & passive" sensors
2 electric bulbs of 100w,200V are put in series & the combination of each bulb is supplied to 100 V . the power consumption of each bulb will be????????
what are the types of control panel used in industries & all electrical purpose ?
if i conncet ct with ct ratio of 600/5 to an energy meter having ct ratio of 100/5, the reading show by the meter will correct, if wrong is there any method to calculate correct value with shown value, if yes please state it.....
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)