If stator & rotor of a 3-phase induction motor have different
no. of poles, will the motor run or not??
Answers were Sorted based on User's Feedback
Answer / naresh chandra jha
For any rotating machine number of stator pole should be
same as number of rotor pole . 3-phase induction is single
exication self starting motor .Thus for 3 -phase stator
winding and 3-phase supply same number of pole will induce
in stator winding and hence motor will start run .
Is This Answer Correct ? | 7 Yes | 2 No |
Answer / deepak24
If the no. Of rotor pole is not eqal to tha stator pole then it will not run. No. Of Stator pole and rotor pole must be same to run 3 phase induction motor
Is This Answer Correct ? | 3 Yes | 0 No |
Answer / vijukumar
yes the statormay have many pols the rotor will have only one
pole as it act as aclose circuit
Is This Answer Correct ? | 2 Yes | 11 No |
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
What are the advantages of thermal power plant?
in catridge heeter watts =110, 260 v , i checked in multimeeter meeter shows 50 ohms but oms law r=v square /w 260*260=67600, and 67600/110=614.5 ohms how to caluclate exact ohms in heetre s
hi frienda We have 750kva cater pillet dg set we are fasing one diffrent proublam in dg we are start dg set after one mint applying load around 450a load but dg was run 3 Or 4 mints after 3 mints dg was shuding down automatic how to face this proublam pls tel any budy
who to select a swicth fuse unit......?
What is metering cubical? What is the use?
why inductivedrop in dc motor neglected
If we impress a dc voltage of 230 V on an unloaded 230 V, 50 Hz transformer it wi A give high secondary voltage B burn out C give secondary voltage as per K D none of these
Classical power system stability was mainly focussed on rotor angle stability but modern power system stability has more focus on voltage stability.Why?
Difference between ups and invertor
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
What will happen if DC supply is given on the primary of a transformer?