How much steel required in 1 square feet slab?
Answers were Sorted based on User's Feedback
Answer / pramansrivastava
.75 kg to 1.1 kg steel required for 1sqft slab.
Is This Answer Correct ? | 138 Yes | 22 No |
Answer / sudhir patil
its totally depend on the design of that perticular
structure.Normally its seen that G + 7 structure is having
2.8 to 4 kg per Sft & High rise building having 9 to 12 kg
per sft.
Is This Answer Correct ? | 48 Yes | 15 No |
Answer / babar
It is only depend that which dia of bar in slab is being used
Is This Answer Correct ? | 19 Yes | 3 No |
Answer / karthick
it is depended upon the structural design but normally for a nominal slab with single floor it is 1.3 to 1.5 kg of steel is used
Is This Answer Correct ? | 20 Yes | 7 No |
In multistory building
----------------------
1- Raft + Retaining wall (In case basement)--- 8kg/sqft
2- basement roof slab i/c non tower slab,
( Column from basement floor to stilt floor + basement roof
slab slab)-- 6.5kg/sft
3 - typical floor / for each floor ___ 4.5kg/sft
Is This Answer Correct ? | 17 Yes | 7 No |
Answer / waseem khattak
you can only assume or can calculate from structure drawing
normaly 30 ton steel required for 1 kanal plot with basement
and rcc wall
Is This Answer Correct ? | 3 Yes | 5 No |
Answer / faizan
i think the 1 sq fit area is consume of 1.5 to 2 kg/sq fit
Is This Answer Correct ? | 5 Yes | 7 No |
can any body tell me that we stdy different grades of concrete $ their strength . as we knot the strength of conrete that this grade or ratio of concrete has this much strength ? even that we go for labortory test what is reason behind that?
What is allowable limit of silt in river sand for concrete
In the different classes or grades of concrete, what is the difference between C20, M20 B20. what are the letters C, M, and B stands for.
for Precast foundation howmany days required we can shift the foundation with american Standards i need reference with section any body can help
Under what circumstances should pot bearings be used instead of elastomeric bearings?
Suppose a new brick wall is being constructed,and the courses and not aligned horizontally,what negetives can it cause?
what would be the rqmnt. of cement and sand (1:6)for building brick wall and also 20mm thick plaster on the wall by same ratio?
why we used primmer in plumbing pipe??? and also what is SCH 80 AND SCH 40
if any chance to getting a set of solved major building estimate with the drawing.(soft copy)
How to find the no. of main bar in circular footing (Central shaft of CLF)
3 Answers N J Devani Builders, Simplex,
what is the ratio of steel and concrete to use in slabs , beams, columns ?
how can we design dia of rainwater pipes ? plez explain by using formula ?