what is mean by single phasing used for electrification in
rural area of maharashtra ?



what is mean by single phasing used for electrification in rural area of maharashtra ?..

Answer / vanthni@yahoo.com

in rural area in Maharashtra we give single phase power
supply only
but the three phase power supply is split in to consumer
by single phase ok

Is This Answer Correct ?    2 Yes 2 No

Post New Answer

More Electrical Engineering Interview Questions

In 6600/√3/110/√3v voltage transformer,how much output voltage in open delta transformer,after removing 1-phase of primary side on transformer?

2 Answers  


define the active power?

0 Answers  


If 3-Ph motor of same rating connected in Delta & Star for same load one by one then which connection take more current in running (not in starting)for full load.(eg 8.5 KW,3-Ph 400 V)

1 Answers   GE,


How much earthing frequency is capable?

0 Answers  


a solar energy installation utilizes a three phase bridge converter to feed energy into power system through a transformer of 400v/400v.the energy is collected in a bank of 400v battery and is connected to converter through a large filter choke of resistance 10ohms.1.the maximum current through the battrey will be.2.the kva rating of the input transformer is.

1 Answers   GATE,






How many points does a Circuit can have?

0 Answers  


a 3 phase slip ring induction motor is wound for 4 poles on stator and 6 poles on rotor; when 3 phase balanced voltage source at 50 hz is applied to motor it will run at a)1500rpm b)1000rpm c)750 rpm d)zero rpm

13 Answers   Essar, PSPCL, PSTCL,


Why 30°phase shift occur in star-delta transformer between primary and secondary?

1 Answers  


how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?

0 Answers  


Should the neutral earthing of 33/11KV D-S transformer, be connected to the earth grid?(Yes/ NO) why?

1 Answers   HAL, Vijai Electricals,


How to check the specific gravity of the two 12 V batteries connected in series to a 24 V UPS and inverter ? will we have to disconnect all the connections and turn off the UPS and inverter or not ? will we have to check specific gravities in each cell of the two batteries ? what is the name of the instrument that is used to check the specific gravity and whats the procedure to check the specific gravity with it ? thanks

2 Answers  


What is the PI test stand for transformer and what is the producer to do this test?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)