Answer / mithilesh kumar

O/p is (-ve) dc volt.
In comissiong purpose -10vdc setting for
bently nevada and sinkawa.

Answer / r_vaya

Bentley Nevada vibration Prob 's ;
Output is 200 mv per 1 mils with the
Tolerance of + - 11 mv 
Range :   10 -90 mils 


That's why mvolts will between 

10 = 200x10 = 2000mV = -2V
90 = 200x90 =18000mV = -18V

when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?

0 Answers  

---

principle of dead weight tester ?

0 Answers  

---

Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?

0 Answers  

---

Flow tax range 0 to 100 mmh2o ,flow rate 40 tons /hr, I want change flow rate example 42 tons/hr so tx range ?

2 Answers  

---

i have one temperature TX in my loop check time once i was remove elament temp gose maximum then i am conect corectly but still now temp showing maximum what can i do this problem?

2 Answers  

---

Please send me the sample question of Instrumentation of hpcl/iocl exam. my mail id hihi_kiholo@rediffmail.com

0 Answers  

---

What are continuances of connecting earthing and shield of branch cables (instrument to Junction box), at the same earthing pot provided on JB? Is it ok, or may produce some problem? 

0 Answers   Process Control Technologies,

---

FOR CO/CO2/O2/NOX applications which of the following manufature is best? and what is the basic principle of gas analysers? ABB/YOKOGAWA/EMERSON/SIEMENS/TELEDYNE/THERMOFISHER

4 Answers  

---

draw the block diagram of a level transmitter ?

0 Answers   Hira Group, Samsung,

---

what is earthing ,grounding in c&i panel?what is the resistance in earthing and grounding of c&i panel?what do u mean by shielding and what is its resistance?

1 Answers  

---

please tel me the calibration of pneumatic controler.

0 Answers  

---

how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.

0 Answers  

---