Answer / p n vadalia

Earth leakage detector is readily available for detecting
earth leakage in 24 VDC, and 110/ 230 VAC supply and it can
be connected on distribution bus bar. This device will
generate alarm when leakage is observed. you had connected
this device at bus bar and on receipt of alarm, for further
identification can be done with the help of multimeter by
measuring individual branch voltage with respect to earth,
here supply vo;ltage is considered floating.

Answer / jigaranadkat

@ Mr. P.N.Vadalia

Sir Won't it make it a grounded supply?

Shall we get the reading on level transmitter only by termination,without commissioning?

1 Answers  

---

what is control valve input and out put

10 Answers   Nirma,

---

What is difference between ESD and PLC please Explain me clearly.

0 Answers  

---

please give me combustion cntrl interlock details? if possidle drawing also?for this one is there any website ?

1 Answers  

---

pls send me the 10 years technical question papers of NTPC AND BHEL

15 Answers   Bhel, NTPC, ONGC, UCE,

---

model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com

0 Answers   Jindal,

---

How to calibrate electronic type level switch low?

1 Answers  

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

0 Answers   Chevron Phillips,

---

WHAT IS SELF CLEAN ELCTRODE IN MAGNETIC FLOWMETER?? WHAT DO YOU MEAN BY THIS TERM??

2 Answers   IOCL,

---

Yokogawa CENTUMVP R6.09 unable to download to Engineering Station with ExaOPC R3.75 The issue is when I try to download the common project section to the Engineering Station (STN) from the HIS in System View, it is unable to connect. The error displayed is: WARNING: Could not connect to equalize destination. (7001) Retrying. Number of retries = 0/1 ERROR: LdXopsLoadMain: connect error 10060 ERROR: Processing terminated due to connection error. (7002) Equalization end with errors. STN0149 ---- ERROR = 2 WARNING = 1 ---- Background: >Updated the ExaOPC software on the STN from 3.60 to 3.75 >STN operating system is Windows Server 2008 R2 >HIS operating system is Windows Server 2016 Stanard Solutions attempted include: >Ensuring all IP addresses are correct and all networked devices can be pinged. >The ability to ping a device using its host name from another device (<ping STN0149> from HIS) >Ensure both devices firewalls are disabled. >The antivirus installed on the STN is disabled. >Ensuring both devices are within the same workgroup. >Added both devices to each other's Host and LMHost files. >Running IT Security tool after changing any administrative settings.

0 Answers  

---

What is the Difference between E/P Positioner and I/P positioner in a control valve? In which applications the respective positioners are used in?

18 Answers   ADCO,

---

how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.

0 Answers  

---