PCC Road Min Grade M 30 for VR standard Mahatashtra load 30
KN. what should be thickness of pavement, width 4m what
should be length of panel.



PCC Road Min Grade M 30 for VR standard Mahatashtra load 30 KN. what should be thickness of pavem..

Answer / Seema Gupta

The design of a PCC (Portland Cement Concrete) road involves several factors, and it's essential to refer to the relevant local design guidelines or specifications for accurate information. However, I can provide you with some general principles:n
1. Thickness of Pavement:n- The thickness of a PCC pavement for a load of 30 kN (assuming VR standard and M30 grade concrete) depends on factors such as traffic volume, axle loads, and subgrade condition.n- Typical thicknesses range from 15 cm to 20 cm or more for heavy traffic areas.n
2. Width of Pavement:n- The width of the pavement (4 meters in your case) is typically determined by design standards and does not affect the thickness calculation directly.n
3. Length of Panel:n- The length of a PCC panel depends on factors like construction equipment availability, concrete strength development, and joint spacing requirements.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Civil Engineering Interview Questions

how much brick, cement, and sand required in 1mtr X 0.23mtr X 1mtr brickwork(1:4), 230mm thick wall and 10mm thick mortar , brick size 230mm X 70mm X 110mm

1 Answers  


if water absorption is more than 25 percent in brick, what is the defect in it?

3 Answers  


As shown in IS 456-2000 minimum cement content is include fly ash?

3 Answers  


it is possiblee to produce concrete with out cracks...

1 Answers  


How to calculate cement qty of M10, m20, m25 ? I got the formula but I lost it.

3 Answers  


TO CONSTRUCT A 1800 SQFT CAPACITY UNDERGROUND WATER TANK HOW MUCH CUFT CONCRETE IS REQUIRED AND HOW MUCH REINFORCEMENT IS REQUIRED. FOR COSTING

1 Answers   L&T,


how to decide the column size and dia of the bar

2 Answers   L&T,


which has high compressive strength between hollow block and brick masonry?

1 Answers  


what is M & 20 of M20 concrete

11 Answers   Bharti, Sheladia Associates, URC Construction,


In concrete mix, water is required . we tried in case of water we are used milk. what hapened

4 Answers   Gammon,


what is quantity of sand required to plaster wall about 1000 sq ft

1 Answers  


What is labor and material payment bond?

1 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5086)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4453)
  • Electrical Engineering Interview Questions Electrical Engineering (16638)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)