Answer / suryalok

yes there r two more methods to damp out oscilation they are
1----- u can use a fly eheel
2----- by using proper stiffness factor of the machine.

Answer / vijendra joglekar

Actually the main reasons for using damper winding in
synchronous motor for starting purpose i mean as we know
the syncronous motor is a inherently strting motor the
other method used for starting a synchronous motor is a
the rotor speeded up by another motor called a pony motor
to its synchronous or near syncronous speed then the
exciting current of motor s switched on the moment rotor
poles are excited ,they mechanically get interlocked with
the stator poles of opposite polarity.Rotor poles are
engaged with the stator poles and both run synchronously in
the sae direction.

Sorry guys the answer is too lenthy please read twice or
thrice in order to get understand..

why DC current not used in Transformer action?

17 Answers   Engineers India Limited,

---

where transformer is installed? a)generating station b)substation c)voltage regulating area

6 Answers  

---

can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?

0 Answers  

---

working method of railway electricl loco in single wire 25000 volt

1 Answers  

---

What sort of protection scheme do you suggest for the protection of a 10 HP motor?

1 Answers   Chevron,

---

Is it possible to control the power in transmission lines by remote controlling method?? if yes explain in details???

1 Answers  

---

An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor frequency at maximum torque point is A 3.33% B 4.44% C 5.55% D 6.66%

1 Answers  

---

what is meant by power and distribution transformer ?

0 Answers   CG,

---

What is “pu” in ee?

0 Answers  

---

what is sevice settings for mccb?How can be it setted?

1 Answers  

---

Whatis the current capacity of 33KV/ 0.433KV transformer on Primary and secondary side/

1 Answers  

---

if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit

0 Answers  

---