Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any other method of damping the oscillation in a
synchronous motor other than using damper winding and if yes
what is it?
- 2 Answers
- 5926 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / vijendra joglekar
Actually the main reasons for using damper winding in
synchronous motor for starting purpose i mean as we know
the syncronous motor is a inherently strting motor the
other method used for starting a synchronous motor is a
the rotor speeded up by another motor called a pony motor
to its synchronous or near syncronous speed then the
exciting current of motor s switched on the moment rotor
poles are excited ,they mechanically get interlocked with
the stator poles of opposite polarity.Rotor poles are
engaged with the stator poles and both run synchronously in
the sae direction.
Sorry guys the answer is too lenthy please read twice or
thrice in order to get understand..
| Is This Answer Correct ? | 2 Yes | 13 No |
Post New Answer View All Answers
What is the necessary condition for stability.
The metal-enclosed switchgear and controlgear is subdivided into three types: 1. metal-clad switchgear and controlgear; 2. compartmented switchgear and controlgear 3. cubicle switchgear and controlgear. What is the main differnence between them. State some example.
Define conversion efficiency of a power amplifier.
what is metering cum synchronizing panel and how it is used?
why does make gain margin and phase margin on same plot.?
How to configure the drives in PLC, through Profibus commnication. And to how to address it?
What are dependent sources?
please send the IS strandard for electrical to sakthi_murugan86@yahoo.co.in
When a square wave is applied to primary of a transformer then what will be output wave form of secondary ?
What is the general power consumption rating of CPU CRT type and Flat type, Monitor,Printer, projector, Scanner?
When is lag lead compensator is required?
Load break swicth maintenance procedure.
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
how to calculte capacitor range for single phase induction motors??pls tel
please send me privious exam's queation papers of section engineer(electrical).
