Interested to Buy Any Domain ? << Click Here >> for more details...
Is there any other method of damping the oscillation in a
synchronous motor other than using damper winding and if yes
what is it?
- 2 Answers
- 5977 Views
- IOCL, I also Faced
- E-Mail Answers
Answer Posted / suryalok
yes there r two more methods to damp out oscilation they are
1----- u can use a fly eheel
2----- by using proper stiffness factor of the machine.
| Is This Answer Correct ? | 13 Yes | 2 No |
Post New Answer View All Answers
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
In ups static switch if i gives the supply at output end it will open the circuit in stactic switch or not if it will open then how it operates.
What is use of starter and choke in tube light
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
What is MS-EXCELL?
How to do stting of vl250 siemens MCCB
I am going to appear for the RRB Chennai Section Engineer online exam. Please send me the question papers from 2001 to date to my mail id:upendrakrishna20@gmail.com,plz send me ,or send any other rrb papers plzzzzzzzzzzzzzzzzzz
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
what is the grounding Calculation formula? spouse i want to provide grounding to 3phase 18kw motor or i want to provide ground to 3phase 10kva dry type transformere or you give me any exemple...... Thanks.
sir i completed apprentice in TNEB.apprentice is eligible for 'c' licence
What is difference between slip rings and carbon burushes?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
what is the difference between b c d curves on mcb
What is the range of the stator resistance of 3 phase induction motor?
