Answer / kalyani

it can be applicable to both lumped and distributed parameters.
but the statements of ohm's law depends on the nature of
elements which follows linear volt-amp characteristics

Answer / sajid

at constant temperature the current flowing through the
condutor is directely proportion to the applied voltage

V=IR

Answer / sajid

ohms law is applicable to motors n generators n circuits

Answer / pinoy

V=IR,
APPLICABLE IN ANY CLOSE CIRCUITS,EITHER CONSTANT OR THER IS
A CHANGES IN TEMPERATURE,
RESISTANCE IS NOT CONSTANT,ANY CHANGE IN TEMPERATURE WILL
BE AFFECTING THE RESISTANCE.

Answer / guest

at constant temperature

Answer / rama moorthi m

Well Anusha,i have expected that constant resistance,mostly
forgot this indirect word.resistance is proposition's
constant not only in temp.

Can a transformer designed for a particular voltage and frequency rating be used for different set of mentioned ratings? Assume that the winding does not get burnt because of overheating at higher voltage. If yes, then under which constraint it is possible?

1 Answers  

HOW TO IDENTIFY THE RELAYS WHICH APPLICATION IN WHICH RELAY USING?

1 Answers   L&T,

What is the problem, if a circuit breaker is not closing.

4 Answers   KSEB, L&T, Siemens,

Define sensitivity?

0 Answers  

Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)

0 Answers  

Waht will happened if reactive power increase in the line? waht about active power increase too?

3 Answers  

How to select a cable size for particular load?

0 Answers   Amit Enterprises, Takasago Engineering, Techno Electric and Engineering,

What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design

0 Answers  

how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc

2 Answers  

how to convert psi into kilo pascal? what is the suction pressure & discharge pressure of chiller?

1 Answers  

transformer phasor diagram under load explain it?

0 Answers  

what is the difference between starter and control panel..?

4 Answers