where the protection CT in neutral of transformer be
located, before bifurcation or after bifurcation and why.
Answers were Sorted based on User's Feedback
Answer / k.prakashchandra
Before bifurcation to measure the full neutral current
| Is This Answer Correct ? | 3 Yes | 1 No |
Write down the name of 2 lady Bir Pratin of Bangladesh
Why consumers are charged based on Kwh basis why not on Kvah basis.
Why we should not parallel the with EB
(1)For 3 No 1500 KVA transformer require on one single bus bar or need to be section through bus coupler means upto 3MVA.(2) 22KV Net work system as ring, How maney I/C required or 0ne I/C and one O/G.(3) What should be rating of VCB for 22 KV line.(4)Electrical/mechanical inter lock, why we need.
IAM WORKING IN THERMAL POWER PLANT AS A TRAINEE.. I WANT TO IMPROVE MY CARRIER., IF ANYBODY KNOWS ANY COURSES., ANY TESTS, ANY BOOKS ,, ANYTHING PLS HELP ME..
In dc motor starter there is less voltage required for holding contactor that's may why it is called no volt coil. but in ac starter why holding contactor is called no volt coil.
why tan delta test conducted in electrical equipmenr
What is the function of the circuit breaker failure relay?
why abcd parameters are called transmission parameters
Why 3 over-current and 1 earth fault relay is used on primary side of transformer? Why 2 over-current and 1 earth fault relay in used on secondary side of transformer?
Why the transmision line are 11,33,63,132kv?
Why are the cores of large transformers built up of circular transactions ?
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)