where the protection CT in neutral of transformer be
located, before bifurcation or after bifurcation and why.
Answer Posted / k.prakashchandra
Before bifurcation to measure the full neutral current
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How to megger test 11 kV cable and the acceptance IR value
explain the types of drives
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
While performing stability test of differintial cts how to know the voltage and current on both side of the transformer?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
How to calculate the sag of OPGW during stringing???
What is the main use of rotary phase converter ?
i applied for the ap transco please forward the freqventley asked QA
How to select the gauge of wire for winding of motors? How to select number of turns for winding of three phase induction motor?
WRITEDOWN FEW RELY CODES
Trafo ratio is 11kV/6.6kv,Vector group is YND11. What will be the effect if secondary is used for earthed system.
Write the programming software name for LG, SIEMENS,Messung,AB
Define what is difference between fuse and breaker?
What happen if 200 KVAR capacitor connected to power continuesly?
what percent do you derate your copper wire when you change from copper buss to copper wire