Interested to Buy Any Domain ? << Click Here >> for more details...
What should be the values of settling time, peak time,
steady state error, overshoot, rise time, MPOS (Maximum
percent over shoot) to keep the system in transient state,
to keep the system in steady state ?
- 0 Answers
- 2236 Views
- I also Faced
- E-Mail Answers
No Answer is Posted For this Question
Be the First to Post Answer
without any excitation we can strt any dc or ac moter?
what percentage of marks in B-TECH is needed for section engineering exam
What will happen if a dc source is given to a tubelight. Will it work or wont it work....
why we use shunt in a rectifier system ?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
Can u start a tube light without a starter?
Why power factor does not occur in DG set ?
Alternator rotor earth fault relay circuit
What is Skin effect in Cable?
how to claculate earth strip size for 1500kVA transformer for neutral and body
why always out of the 3 phase(RYB) of supply, in Y phase w.r.t the voltage is higher? on R & B phase the voltage will be lower as compared to Y phase?
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
-
Civil Engineering (5086) - Mechanical Engineering (4456)
- Electrical Engineering (16639)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
