What causes steam turbine governer hunting?

Categories >> Engineering >> Mechanical Engineering
Suggest New Category

Question Posted / mazher

7 Answers
31916 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What causes steam turbine governer hunting?..

Answer / mazher

Loss of inlet steam pressure to turbine is one of the cause
of governor hunting in reaction or impulse turbine. In
backpressure turbine variation in outlet pressure of steam
also causes governor hunting.

Is This Answer Correct ?

40 Yes

11 No

What causes steam turbine governer hunting?..

Answer / ranjeet verma

One is Hunting
occurs if governor
is more
sensative.second
is improper setting
of governor.third is
linkage assembly

Is This Answer Correct ?

18 Yes

3 No

What causes steam turbine governer hunting?..

Answer / ram

may be oil line problem or governer problem hunting came

Is This Answer Correct ?

17 Yes

4 No

What causes steam turbine governer hunting?..

Answer / sani

Blocked governor oil strainer and fluctuation flow due to persistent load variation.

Is This Answer Correct ?

12 Yes

2 No

What causes steam turbine governer hunting?..

Answer / anup sharma

water contamination in turbine oil. in small turbine turbine lube oil is also used as control oil, if there is water contamination governor may hund

Is This Answer Correct ?

3 Yes

1 No

What causes steam turbine governer hunting?..

Answer / sarforaz

Onr of the cause Turbine governor hunt if slip ring motor's carbon and slipring worn out which loaded to turbine.

Is This Answer Correct ?

0 Yes

0 No

What causes steam turbine governer hunting?..

Answer / biman adhikari

properly check the values of pid.if nessecary change it
according with the consulting manufacturer.

Is This Answer Correct ?

2 Yes

8 No

Post New Answer

More Mechanical Engineering Interview Questions

tell me 1 name of device where work & heat transfer is +ve

3 Answers

whose unit is Psi ?

5 Answers

WHY ISOMETRIC VIEW LOOK LIKE 3D?

4 Answers

which bearing use in lathe spindle

7 Answers Denso, Reliance,

Explain how can I see where pipes are behind the wall?

0 Answers

Give one example of metal classified as per structure as bcc, fcc, hcp and ccp.

0 Answers

Respected Sir, Please send me the technical question paper of ONGC of mechanical branch.I m in urgent need of it.

7 Answers NTPC, ONGC,

How a Diesel Engine Works in Generators?Explain with Labelled Diagram.

2 Answers

Can we use pure oxygen in IC engines instead of air?? what would be the advantages and disadvantages of using it?? Have any steps been taken about this??

5 Answers College School Exams Tests, TATA,

If an ID Fan is designed for a suction pressure of - 250 mm wg and discharge pressure of +150 mm wg, and it is installed in a system where the required system resistance at suction is only -50 mm wg, will the ID Fan be able to produce a discharge pressure of +350 mm wg?

1 Answers

what is procedure of measuring operating length of mechanical seal .(in case of centrifugal pump)?

0 Answers

WHAT IS THE MERITS OF INTERNAL COMBUSTION ENGINE?

1 Answers

For more Mechanical Engineering Interview Questions Click Here