Answer / kanhaikumar

critical speed is the
theoretical angular
velocity that excites the
natural frequency of a
rotating object, such as a
shaft, propeller,
leadscrew, or gear.

fd fan working

2 Answers  

---

2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

0 Answers  

---

what is c.c in automobile

7 Answers   TVS,

---

If we put a ball(made by metal) of dia 10mm on table of size 200 mm*200 mm . weight of ball is 10 kg(98.1N) it should point conact with table than what is the stress acting on table and why?

3 Answers  

---

What is the effect of changing in cc of the engine?

3 Answers  

---

Which reactor uses primary coolant as fluoride salts of lithium, beryllium, thorium and uranium ?

0 Answers  

---

what is shock in pipe line how it is happening

2 Answers  

---

Can you use motor oil in a hydraulic system?

0 Answers  

---

Define a uniformly distributed load.

0 Answers  

---

sir i am working in CIM Technologies , AS DESIGN ENGINEER, I WANT TO PREPARER FOR INTERVIEW TO THE DESIGN PLEASE SUGGEST HOW TO PREPARE FOR INTERVIEW

0 Answers   HAL,

---

A simple problem involing in hoops stress. For sphere: M= [3/2]*p*V*[density of pressure vessel material/Maximum working stress it can tolerate] For Thin walled pressure walls: Hoops stress or stress in the radial direction =p*r/2t ?

0 Answers   Bhel, JPMorgan Chase,

---

What are the procedures of starting of diesel engine?

4 Answers  

---