What is CNC

1 Answers  

---

How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?

0 Answers  

---

what is the differnce betweeen hart and smart tx

3 Answers  

---

why is honed type flow orifice plate? what purpose it used? how to select this?

4 Answers  

---

what is difference between fork type and capacitance type level switch. where it is using

0 Answers  

---

what is sequence table in DCS . make a logic in sequence table for tripping of ID fan in Boiler(in YOKOGAWA CS 3000 DCS).

1 Answers   Yokogawa,

---

What is the Difference between PE,IE and ISE

2 Answers  

---

I want to measure level under vaccum by using DP Tx and vaccum vary between -500 to -670 mmHg and process fluid is accetic anhydride if consider process fluid density 1 kg/cm2. how to calibrate Tx ? consider level is 0 to 100 Cm.

1 Answers   CCC,

---

what is fire and gas system?

2 Answers   Andhra Petrochemicals Limited,

---

my data card only does run in my mobile so how can change it that it run other mobile & computer and i can stor data in my data card

0 Answers  

---

Where are use of pressure,level,flow switches?and what is input and output

3 Answers  

---

What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers  

---