Answer / bk mishra

A 1 ton Air conditioner is appx 1400 watts . so
1400/230=7.8 Amp is the runing current.

Answer / aks

Mr Answer is correct. As a thumb rule we choose breaker of 2 - 2.5 times of rated current.

Answer / sanjay singh

there is difference between running current and starting current.can anybody answer what is the starting current for 1.5 ton 3 star ac

Answer / bala_vlsi

Mr. Mishra as perr you calculation 7.8 A then why all the
people are recommended 15 /20 A BEREAKER for the above load

Answer / abhay sisodia

1 Tonn of refrigeration consumes 1400 watt approx. For
coverting watt to ampere we have to divide 1400 to 230volt
it comes approx 6amperes for safety meausres we select 3
times bigger MCB that means 18ampere.

Answer / rajesh

Checked the Current of LG 1 Ton AC with Clamp Meter Stable Current is 0.3 Amps and When Compressor is On it is 4.78Amps RMS

Answer / tony

All the answers are actually wrong. MCBs can handle quite a larger current (2-15 times, depending on type) for short period of time so you don't consider inrush current.

Type B: 3-5 times
Type C: 5-10 times
Type D: 10-20 times

The breaker in the distribution box usually is dependent wire gauges. You can adjust the mcb with socket according to load.

Use type C for ac. Only use 1.5 times of the running current. I use 13A for 1.5 ton ac.

Answer / qaiser shah

well i ve 1 ton LG Window AC, i ve checked its running amperage is 6.23A, So my answer is 6-7A in running , i ve connected a breaker of 10A which does not trip on starting or running... i dont know the starting current...but i think may be 9A?

Answer / amartaya

32 A i MCB s perhaps wrong because if B type it can hold up to 95 A to 140 A for o0.05 seconds approx and for C type it can hold 150 to 300 A approx for 0.1 seconds . 16 A C type MCB will be enough.Thanks .

Answer / tech mech

Check the Specification sheet of the Air-conditioner for wattage consumed or running current in Amperes. Starting current for compressor motors can be safely assumed as 3.5 times the running current. MCB (breaker) rating should be 1.5 times the max current required that is the starting current. So, Breaker rating should be 5-6 times Aircon running current. This is unique to appliances with motors like Refrigerators, Air conditioners, Washing machines, water pumps etc.,

what is the need of starter in tube light and what type of starter is used in that?

0 Answers   Sedemac, Sepco,

Which one is more accurate servo or stepper motor and why?

2 Answers   BARC, HPT,

State Maximum Power Transfer theorem.

0 Answers   ABB,

Differentiate between Zero and Negative sequence current

0 Answers  

What is the purpose of stablization resistor in high impedance bus bar protection

0 Answers   Jindal,

What are the different types of controllers?

0 Answers  

what is the Knee point Voltage?

3 Answers   AAPT,

what is the consuption rating of motor in one day

1 Answers  

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers  

The temperature rise in the sys, which leads to ….. a) Increases stress& length b) increases stress but decreases length c) Decreases stress & increase length d) decrease stress & length

1 Answers   Engineers India Limited,

what is Anti-pumping?

0 Answers  

exact difference between electronicsand electrical

5 Answers