Answer / rajesh kumar

thermocouple works on the principle of seeback & peltiar
effect
if any two metals are placed at two different places having
junction j1 & j2 normally hot junction & cold
junction .heat is transferred from hot junction to cold and
an emf is produced. this produced emf is equal to the
temperature at that point

Answer / surya2322

thermocouple works on seeback effect
i.e when any two different metals are connected together,
an e.m.f.generates, this e.m.f is a function of the temperature

The general form of this relationship is:
e=a1t1+a2t^2+a3t^3.....an+t^n

Answer / surya2322

thermocouple works on seeback effect
i.e when any two different metals are connected together,
an e.m.f.generates, this e.m.f is a function of the temperature

The general form of this relationship is:
e=a1t1+a2t^2+a3t^3.....an+t^n

Answer / anup mistry

when two different metals wire are connected
it form two junction and when this two junction
are kept in different tempreture then the emf is
produced between them.

Answer / s.farhan haider rizvi

thermo couple work on seeback effect and paltier
effect,when two differant metals conected together at hot
junction if we applyed heat on hot junction so we founded
on cold junction e.m.f (mv)

Answer / surya2322

thermocouple works on seeback effect
i.e when any two different metals are connected together,
an e.m.f.generates, this e.m.f is a function of the temperature

The general form of this relationship is:
e=a1t1+a2t^2+a3t^3.....an+t^n

can any one explain in which term we are flow flow is it volumetric r is it mass? and y

0 Answers  

What is the diffrence between digital signal processing and discrete signal processing?

0 Answers  

Explain Gas Turbine startup and shutdown sequences

0 Answers  

what is hall effect?where it is use in power plant?

2 Answers  

what is the function of 3 way manifold valve in a closed loop system?

1 Answers   Emerson,

What is the purpose of valve positioner. Explain 4 uses.

2 Answers   SRACO,

what is difference between PLC and DCS?

10 Answers  

why 4ma show higher zero ? i have transmiter flow renge 0-1000 m3/h but 4 ma show in monitoring 200 m3/h and 20 ma show 1000 m3/h i want when 4ma show 0 m3/h and 20ma 1000m3/h

3 Answers  

can i calibrate DP transmitter online (while Tx in Service) if yes ,how?

1 Answers   CEPC,

if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?

1 Answers   MPL,

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers  

is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?

0 Answers