Answer / naveen

A ratio can not be given directly that suppose to be a
desgin mix and after testing the material property only a
ratio can be arrived at.

Answer / shunmugapriya

it is based on design mix only. i think we can fix by
using trial error method

Answer / uday

1:1.65:2.76

Answer / shaikh parvez

Approximately 1:.75:1.5

Answer / annan

1:.7:1.74

Answer / shankar

1:4:8

what is singly & doubly rc beam? what is difference between them?

6 Answers  

what are the stress act on circular slab?

1 Answers   NSL,

What are the different approaches in designing the floors of the service reservoirs?

0 Answers  

what is tensile strength of {6,8,10,12,16,20}mm dia bar? also there were any formula?

4 Answers  

What is meant by Rolling Margin? & which material will effect in this ?

2 Answers   Construction, L&T,

what is polity

0 Answers  

what is difference of NP3 and NP4 pipe and what is the thickness of 1000mm dia NP4 pipe

1 Answers  

Why do we provide development length in RCC?

4 Answers  

how to find hardness of water?why it should be determined?

0 Answers   L&T,

how much should we assume for the weight of foundation ??

1 Answers   Unitech,

how to calculate sand in CFT from a concrete foundation (m^3)???

1 Answers  

how to do rate analysis for P.C.C 1:4:8 for 2.83cum(100cft)

2 Answers   Unity Infraprojects,