Answer Posted / shankar
1:4:8
| Is This Answer Correct ? | 4 Yes | 23 No |
Post New Answer View All Answers
what is the price of a cubic meter of concrete on international market?
Explain the water bound macadam roag
please, what is the required bar for a column of 6mx6m the dept is 405mmx300mm,its an axially loaded ?
what is the cost differene of a same structure when it is constructed with brick masonary, and when it is constructed with concrete as a frame structure.????????
what is the relation between pitch of steel and depth of slab?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
at which depth the construction of tunnel is economical from cost and engineering aspect.
How to calculate concrete in percentage wise ,for example cement 18% sand 40% aggregate 40% and Stell 2% ,I need and??
GIVE US DETAIL OF YOUR PRESENT EMPLOYMENT STATUS?
how to absorb to site basic corrections? which are the important correction?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
Why are pull-out tests performed for soil nails?
how to calculate reinforcment in staircase cranked beam?
How do you change a dimension value in solidsworks?
