Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / suresh apgenco
isolation transformers are used to isolate faults which
occur on the primary side not to transfer to secondary
side.
| Is This Answer Correct ? | 14 Yes | 0 No |
Post New Answer View All Answers
how is find out kwh step by step
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
whatis the commertial spec. of distribution boards ?
why do you add the load short circuit impedance when considering short circuit amperage. It seems that you should only consider supply. If you need to consider loads and you don't know what loads are to be added , what would be a good sub-transient reactance rating for the loads?
what is the difference between an alternator and a synchronous motor
in 132kv substation CRT means
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?
Why control of DC motor is simpler?
what are the assumptions made in swineburne's test?
Proviiding the Dedicated N earth and individual Body Earths ,Finally these all looped /Now my Question :- will it not harm in case of Transformer Fault current flows in Dediacted N Earthing to Looped Body Earthing.
how to find ratio of CT & PT in 66/11kv 12 mva supply system ? explain with calculation.
What is meant by stator? What is meant by rotor?
1. Can a 12v DC choke operate a 60v/12w PL lamp ? 2. Can a 230v ballast fire / operate a 60v/12w PL lamps.
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
