why capacitor bank always connected in delta,why not in
star to a system?
Answers were Sorted based on User's Feedback
Answer / biswajit goswami
star connected capacitor bank draw less current than delta connection, when we connect the capacitor bank in star connection in 3 phase circuit it reduce less reactive current than connected in delta ,so delta connected capacitor bank is more effective,so we connect capacitor bank in delta connection.
Is This Answer Correct ? | 2 Yes | 3 No |
Answer / sumit kumar
In delta p.f. is improved 3times as compared to star.
That question was asked in LMRC
Is This Answer Correct ? | 0 Yes | 1 No |
Answer / guest
hi arvind,
my friend i agree to you when you questioned the use of high
impedance in the system but don't you know that capacitor
only offers capacitive reactance which mean impedance is 0+jXc.
Is This Answer Correct ? | 9 Yes | 11 No |
Answer / ashu
please elaborate or mention the link about how the star connection is effectively in series form.
thanks!
Is This Answer Correct ? | 0 Yes | 2 No |
what would happen nif we increase or decrease the capacitor of a flood light.
how to calulate bearing number of any motor ?
how to select electrical equipment such as fuse,dg,transformer,motor,msb,wire,cable as per the connecting load..please mention any books to design,take licence
0 Answers Gujarat Electricity Board,
operation principle of a generator? Gss, Diesel and HFO which is better and why?
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
i need to calculate high voltage line power factor daily basics but there is meter reading kwh and kvah while calculating power factor kwh/kvah formula was right. for examble there is point c=13kwh c=1.8 lag c=1.2 lead and c=14.5kvah like that i know that p.f =kwh/kvah but c=1.8lag kvarh and c=1.2lead kvarh points i dont know if u know please reply
I have two power supply.a)govt. power b)Captive power.3 phase load connected inside factory.when source change govt. source to captive some motor rotate reverse. Is phase sequence changes when if off & on?If I off generator & on it again is it possible to get changed phase sequence??
According to IEC60034-14, When the vibration monitoring system required for motor Bearing. above which KW, it is required? and for what type of bearing the vibration probe is provided.
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
what is the meaning of Air condition "TON"
distribution is maximum done by a)radial b)network c) parallel d)b & c
In iduction motors the current is higher than normal for both the cases when the voltage appllied is more than the rated as well as less than the rated, why?