Answer / Priyanka Chauhan

Nichols Chart is a graphical tool used in Control Engineering for Bode Plot analysis. It provides a visual representation of the frequency response of a system, showing both magnitude and phase shift as functions of frequency. Nichols Chart helps to determine the stability, gain margin, phase margin, bandwidth, and damping ratio of a control system.

Transformer not operated in dc ! why?

10 Answers  

---

what is the advantage and disadvantage of billing in kwh and kvah by electricity board .

6 Answers   Nespak, NTPC,

---

Will an earth leakage trip be activated if the component or wiring is faulty on low voltage equipment.Example An electrical Cat Scarer placed in the garden and water gets into the wiring.

1 Answers  

---

Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632

1 Answers  

---

What is the difference between tie bus and bus coupler?

1 Answers  

---

My ups output shows 230 v between phase and neutral,but show zero between phase and earth.Is the system/installation is correct.If not what will be the possible reasons

4 Answers  

---

Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks

1 Answers  

---

what main difference betwenn invetter & ups & major difference

2 Answers   ABB,

---

what is phase to phase fault? what is line to line fault?

6 Answers  

---

working method of railway electricl loco in single wire 25000 volt

1 Answers  

---

in 220/132 substation in place of PT what equipment used & what r the role of that equipment

2 Answers  

---

why inductance is not present in a incandescnt lamp?

2 Answers  

---