Answer / ashok mishra sddiet

because the losses in the motor is dependent on PF

Answer / gajanan

the load connected to motor is mechanical. it is eqvt to
resistive load inelectrical. and o/p of resi. is in watts
so o/p of motor is in watt or kw

How to calculate HV Cable Sizing & what are the factors to be considered for selection?.

2 Answers  

---

what sis the testing procedure of transformer and ht panel?

1 Answers  

---

what will be the effect if you were using different brands of outlets?

0 Answers   TESDA,

---

How turns ratio test is done in three phase transformers?

2 Answers  

---

If single phase voltage level is 230V than why three phase voltage level is not 660V ?, but it is only 440V.

16 Answers   BSNL, DOS, EFS, HMT, L&T, TCS, ThyssenKrupp,

---

what is the difference between the characteristics of two different phase bushing of any transformer

0 Answers   NIT,

---

Why not LED burn after showing alarm,as Alarm volt is 11- 13,But LED is of3 volt,why it isnt Burn??

1 Answers  

---

What is the ideal position cooling fan inside the dc motor?

0 Answers   Kay Bouvet,

---

IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?

0 Answers  

---

what is the difference between the diode and the rectifier

17 Answers   Avalon, L&T, Mahacol Trexim,

---

what is safety measures of alternator.

10 Answers   HP, MNC,

---

In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.

0 Answers  

---