what will happen while giving 2 phase supply to 3 phase motor
Answers were Sorted based on User's Feedback
motor will burn aftersupplying 2 phase but if we apply a
capacitor of appropriate value it will run
Is This Answer Correct ? | 8 Yes | 1 No |
as there was no rotating flux, so there was no question of
any rotation.the motor will burn.the two coils connected in
series ( against which you have connected the two phase
supply ) will carry huge current ( limited by the impidance
of the coils )and ultimately cause it to burn.( this is
most commonly named as single phasing in 3 phase system.
Is This Answer Correct ? | 8 Yes | 3 No |
Answer / rajan.s
Motor not run only homming sound but stating winding series capacitor connected
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / wadosky
the windings will nt burn. De motor will be
homming but wont run since de strnt of de mag
field generated will nt be enough
Is This Answer Correct ? | 0 Yes | 1 No |
why DOL starter is use in induction motor as it is not reduce the starting torque
i have one transformer 1000kva, 11/.433kv. we are using 200/5 amp. ct unit for measuring purpose, & one 800 amp. V.C.B Unit for the same t/f operate, i wants to known the primary current of T/F is only 53 amp. why we used 800 amp. V.C.B ? & 200/5 amp. CT Unit.
Explain the following and how these are working with PLC Unit 1 I/O Module Card 2 Adaptor Card 3 Ribbon Adaptor 4 I/O bus 5 I/O Devices
what will happen at secondary side of transformer if i increase voltage at primary side?while V1*I1=V2*I2 will secondary voltage or current increase?
Why dc shunt motor in lathe, compound motor in rolling mills
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
What is the difference between Neutral and Eatrh?
What conditions are required for transformer to operate at low frequencies ?
What is the max value of neutral current that can be allowed in system?
how motor should be connected i.e star-delta or star-star or delta-delta ?
how to find transformation ratio of squirrel cage induction motor
why synchronization done in clockwise direction?