How wti of transformer works?
Answers were Sorted based on User's Feedback
Answer / sangeetha.np
The wti is the winding temperature indicator.this is
because the winndings get heated continously, so when it
goes beyond the limit,it has to be indicated tats wat we go
for wti.
Is This Answer Correct ? | 13 Yes | 27 No |
Answer / dinesh kumar
The WTI has temperature imaging sensors that fitted on some
points of winding. it has four trippers. two to trip the
alarm and two to ON the oil pumps for oil circulation.
Is This Answer Correct ? | 2 Yes | 17 No |
Answer / krunal
WTI is Winding temperature indicator working principle of
the WTI is as same as the conservator tank busholz relay.
When the winding gets heated so as the oil filled in the
main tank gets heated. Now there is this mercury switch
bellow type whic pushes the pointer in the direction as
heat increases. which in turn cause the pointer deflection.
this is how the WTI indicator works.
Is This Answer Correct ? | 1 Yes | 20 No |
Answer / dinesh as pritech
Transformer is a static device which is used to transfer the
electrical energy one place to another place without any
changing in frequency.
Transformer works on the principle of mutual induction.
Its consits of two winding is known as primary and secondary.
The magnetic flux moves primary to secondary winding.
Is This Answer Correct ? | 2 Yes | 22 No |
Answer / neeraj dubey
transformer have two winding primary & secondary when gives
ac supply voltage then winding produce fux and secondary
winding behaves like magnet lines whos cuts the flux and
produce emf in secondary winding. themn it work .
transformer has work depend upon no. of turns and cores
dia.
Is This Answer Correct ? | 4 Yes | 42 No |
wchich motor we are using in mixer?
i work as a technician at a private company.. i used to take amp reading for certain appliances such as air con.. the problem is when i clamp the neutral, wire there is a current reading.. from my understanding for single phase system neutral should not have current unless if the circuit is not complete.. yet the air con still work
What is MODBUS Controller Used for BMS Mointoring???
GIVE CONDITION FOR MAX EFFICIENCY OF 3-PH TRANSFORMER AND D.C MOTOR
Why Humming noise originated in Starter motor and how it was generated ?
Where the ON LOAD TAP CHANGER is provided in the setp up transformer?
what is first ground fault & second ground fault. This is used in rotor protection of alternator.
What shall be the minimum distance to be maintained between two power cable in a common trench?
what about electrical pannel.? What is meant by plc pannel.?
How to know Resistance and Reactance value of main and aux winding of single phase capacitor start capacitor run induction motor to find capacitor value?
We have AC-transformer 110/13.8kv,40MVA.If DC-Voltage=110kv is applied in its primary what will happen?
Our Slip Ring Induction Motor Frequently tripped By Earth Fault While Starting time and in Normal Operation Time also Kindly Let me Know the Reason. Application Ball Mill - Cement Mill