Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / dinesh kumar
The WTI has temperature imaging sensors that fitted on some
points of winding. it has four trippers. two to trip the
alarm and two to ON the oil pumps for oil circulation.
| Is This Answer Correct ? | 2 Yes | 17 No |
Post New Answer View All Answers
why would the rotor rotate at sub synchronous speed against the direction of rotating flux when d rotor of 3 phase IM is connected to 3 phase balanced supply and the stator windings are shortcircuited ??
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Type of motor stater detail and working detail
why the protection turbo generators is most complex?
Difference between a pilot wire and a normal conductor?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
Is vtg is controlled by the resistor? if else how much?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
how can decide the current rating of oltc
difine electrical ballast in HPSVL
Disadventage of cable-gland earthing if any ?
what is the role of transistor in Circuit?
Air refrigeration cycle works on the
Dear all, i completed M.E(Power Electronics & Drives) 2011 passed out having 78% so i need job in core side but i don't know how can i receive the calls from electrical companies and i uploaded my CV in naukri, times jobs etc.. In that iam not recieved any mails from good companies so give me best procedure plzzzzzzzzzzzzzzzzzzzzzzzz..... Thanks, K.Linga Reddy Email-id:-lingareddykmthm@gmail.com Ph no:-08015402078
how to control dc motor?
