How to consider the flow directions for control valve (Globe)
Is the there any easy understanding in order to select the
flow directions?
Answers were Sorted based on User's Feedback
Answer / goerge mathews
You can always look after the arrow mark on the valve ,
bcos in my understand we can find this in any kind of
valve which tell the direction of the flow.
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / minesh
First of all see the flow direction arrow on the control
valve body, if you didnt find,check the orifice name plate
(in which side write d & D and some data) its up stream.its
can help you. (as genral parctice tansmitter should be in
up stream, some time it can very on process demand)
Is This Answer Correct ? | 3 Yes | 6 No |
what is the procedure of O2 analyser calibration?
how in the 2 - wire transmitter, 24v supply and the 4ma signal gets in the same path?
How to calculate mmwc values into tonnes?
meaning of SMART
what is flow and flowrate? definate and diffrentiate it? pls post a valid ans thanks in advance
difference between dcs & pld
hello this is dhinakar subramanian. how to piping and instrumenation drawings and also how to create the data sheets...
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
what type problems create in radar level transmeter and what is its solution
re i got gre score of 950,and toefl of 69 is this score sufficient actually my husband is presently in US i need to go please help me
how eddy current loss in probe and induced gap voltage accros probe trip and shaft
why 1 to 5 vdc is used for output measurment