Answer / umesh kansara

Following factors are considered during the synchronization.
1)Frequency should be same
2)Phase angle should be same
3)Voltage level should be same
4)Impedence should be same
5)RPM should be same

Answer / anurag sankar sengupta

the following factors are very much important in case of doing synchronization.....:
1> the incoming and running alternator should have same operating frequency.
2> the output characteristic of prime mover should be same for both the alternater.
3>they should have the capability to produce same type of output... ie.sine wave waveform.

Answer / karthik.j(cce)

1.voltage
2.Phase sequence
3.Frequency
these three things are should be same for both the
alternator.

What is Diff. btw Cat-5 & Cat-6 Network Cables???

3 Answers   Emerson,

---

what happen if rotor earth fault in AVR system?

1 Answers  

---

magnetizer priciple

0 Answers  

---

at what rate the micro controller increment its timer....is it 1micro seconds or 1/(12*10^6) seconds

0 Answers  

---

explain supply side and demand side energy management with advantages & disadvantages

0 Answers  

---

WHAT IS DIFFERENCE BETWEEN idmt and instentanous relay? is idmt is used as back up protection or else?or when instantenous relay saturates IDMT will operate???

1 Answers   BK, REL,

---

How to increase the specific gravity of DG batteries?

3 Answers   SCS,

---

what does work of electrical technician in industrial

1 Answers  

---

what happen when power factor of 2 parallely operated transformer become equle?

0 Answers   Flextronics,

---

What is farmula to calculate Diesel cunsumption as par KVA.

3 Answers   HCL,

---

how point on wave controller works.

0 Answers  

---

when voltage increases then current also increases then what is the need of over voltage relay and over current relay? can we measure over voltage and over current by measuring current only?

1 Answers  

---