What are the factors to be considered during the
Synchronization?
Answer Posted / karthik.j(cce)
1.voltage
2.Phase sequence
3.Frequency
these three things are should be same for both the
alternator.
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
How can I calculate per unit (KWH) fuel (Gas/ Diesel both) consumption 1MW unit?
How to minimize the eddy current losses?
How to calculate the time setting for star connection in star delta starter? For example 10KW 3PH Induction motor.
Can we test the alignment of End shield and stator of turbogenerator without rotor insertion? Also how to fix maintain the alignment at site installation?
What is mean by hot and cold loop testing?
in shunt clippers why a resistor is used in sereis with the input
dear sir/madam i want to get some knowledge about RRB EXAMINATION(section engineer) 1- what is minimum cut off 2- wht portion is major portion . 3- can any body provide Sample paper. thanks & regards ashish
i applied for the ap transco please forward the freqventley asked QA
what is the main difference between power devices and signal devices
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
what is the role of transistor in Circuit?
For an induction motor wat is the loading/unloading cycle duration or interms of L/UL ratio/ percentage?
Pls mail me utility & Dg related question with answer
what is the ms flat constant for calculating earth mat design calculation?
please tell me, how i clear the objective test? when i studied form the one book after i solved the objective ,that time i solved that qes. but if i tried solve objective form the other book then i could not solved these que.