Answer / prabhas

You should apply the voltage step by step till the double
voltage capacity of the cable. this is during only in the
1st time of test for 2nd time onwards 1.8% is preferble.

Ex:33KV: You apply till 65KV

Answer / dharmaraj

you apply voltage 80% factory testing.......

if example factory testing 70kv means

you apply 70*0.8 = 56kv. for 33kv busbar........

when will be the iocl interview results i faced interview on 8th september 2008 iam from electrical branch i faced interview for the post of electrical engineer??????????????????????//

0 Answers  

---

what is negative d.c. voltage, why this voltage is used in base transciever station.

0 Answers   Vintage Air,

---

we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.

0 Answers  

---

Dyn1 transformer vector group testing how to do

0 Answers  

---

As you achieve greater success with the company after some years, Will you like to be a share holder in our company?

0 Answers   PESPL,

---

if 2500 KVA TRANSFORMER CAPACITY.33KV INCOMING HOW ARE AMPEAR PRIMERY SAID

3 Answers   Cipla,

---

what is the difference between OSR and BUCHHOLZ relay of transformer?

1 Answers   Bhushan Power Steel,

---

can we connect both delta and star to the transformer secondary and for what reason?

5 Answers   Power Grid,

---

what would happen if reactive power (kvar)is increased (more)or decreased (less)? how much exact reactive power should be maintained? and what should be done for that

0 Answers   ABB, Siemens,

---

Which type of alternator used in power station?

2 Answers  

---

For Electrical / and Electronic Systems, when we say efficiency is 80%, then what happens to other 20% from the Power consumption.? I.e. what happens to this?

1 Answers  

---

In brushless excitation system how generator field current is measure even if the slip rings are absent?

3 Answers   Adani,

---