While testing the 33KV Busbar by using Hipot kit, what
should be the test
voltage we have to apply?
Answer Posted / dharmaraj
you apply voltage 80% factory testing.......
if example factory testing 70kv means
you apply 70*0.8 = 56kv. for 33kv busbar........
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
is it necessary to earth the rmu before cutting off the transformer winding?if yes why?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
How does a television work?
how could we calculate the no of outgoings from a 800 watt distribution board
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
-What shall be short circuit current of LV switchgear for a 1000 kva, 11.415kv, 3 phase tranformer with 5% reactance.
Why frequency changes due to load variation in power system ? i.e why when load increases frequency decreases?
How much dc volt applied in cathodic protection system?
How the annunciator works ? How to do its wiring
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what is meant by LCR meter? where its useful ?
we have two generators different capacity on 15 MW and other 6MW at 11 KV , 15 MW gen. bus short level current 40KA,and 6MW short level current 25KA,, length of cable 100MTR between 6 MW from 15MW gen. for bus coupling . kindly tell any one can we use both NGR OR one NGR from any GEN. BOTH NGR has diff. rating. Tariq pakistan
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
What test must you do before powering up a circuit that you have been working on?
What is power in wattage of 8.5 TR AC