Answer / iamdon

Earthing of a machine is checked with the help of a devies
called earth tester.For proper earthing, reading of tester
should be from 4-10 ohms approximately.

Author:arbelectbit@yahoo.com

Answer / k.cs

This method of checking is ok,but there is a chance of
electrical shock may be felt by testing person by mistake.
Hence it is always advisable to test at electrical socket
with out connecting machine in the socket, that is there
willbe a 1-3 voltages should be in between neutral and
earth points.

Answer / puneet

earthing we can check by measuring the voltage betwwen phase and machine earth point if we get the voltage then it is ok

Answer / avi gulia

earthing can be checked by either checking voltage between the phase and earth or by checking voltage between the neutral and earth it should be 2 to 4 volts.

Answer / b soni

Earthing of a machine is checked with the help of a devies
called earth tester.For proper earthing, reading of tester
should be from 1-5 megaohms approximately.

If you don’t have coal, salt and copper, then how would you earth your connection temporarily at a camp site.?

0 Answers   Bajaj,

What is meant by impedance? difference between high & low impedance ?

0 Answers  

why do we carry out winding resistance test?

0 Answers   MahaGenco, MAHINDRA,

Why ideally the internal resistance of voltmeter should be infinite and of an ammeter be zero

2 Answers  

l&t switch FN 63 handle position can we change

0 Answers   OPTCL,

hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"

0 Answers  

what is ATS?and its function or operation in power system with its layout.

1 Answers   DLF,

What are the different condition monitoring techniques for a motor?

1 Answers   DAE,

Write the programming software name for LG, SIEMENS,Messung,AB

0 Answers  

y we use neutral,all r told its used to for closed path..k its a just used to closed path,in a transmission line y we put same conductor used n both phase and neutral..if we use less than phase conductor in neutral mean we ll reduce cost its right r wrong..if we use mean any problem occur in transmission line..

0 Answers   ME,

E.B sending end to receiving end 33kv ug cable laid 8Km,receiving end to ss1,ss2,ss3,ss4 all are Approx 800 Mtr,can go for 33KV to 430V or 33kv to 11kv in receiving end and 11kv to 430 near ss ,which one is good for technically and economically.

1 Answers   JLL,

WHAT ARE THE DFT AND RMS MEASURMENTS PRINCIPLE IN NUMERICAL TECHNOLOGY OF POWER SYSTEM ?? WHICH IS BETTER IN WHICH QUANTITY MEASURNMENT??

1 Answers