How check proper electrical earthing of machine.
- 5 Answers
- 15303 Views
- DRJ ARDE, I also Faced
- E-Mail Answers
Answer Posted / iamdon
Earthing of a machine is checked with the help of a devies
called earth tester.For proper earthing, reading of tester
should be from 4-10 ohms approximately.
Author:arbelectbit@yahoo.com
| Is This Answer Correct ? | 16 Yes | 8 No |
Post New Answer View All Answers
all the technical question with answers pleas send your email id ramar_eee@yahoo.com
define reflection method?
how to avoid Saturation in C.T?
Difference between a pilot wire and a normal conductor?
WHAT IS THE DIFFERENE IN ACTION OF MCB,MCCB,RCCB
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
how to calculate the earth mat design in 132 kv substation yard ????
draw the block diagram of fire alarm?
what is mean by descripiency relay? & wht is its ansi code?
what is transient voltage?
how i can calculate the size for fire cable
work of choke in florocent tube circuit ?
how a flip flop can be used as a latch?
Consider three heater bank connected in 3 phase star with neutral.Each heater bank connected in each phase.So each phase get 230 volts supply.my question is,during balance condition, current flow in neutral or Not
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
