why we used star delta starter for above 5hp motors

Answers were Sorted based on User's Feedback



why we used star delta starter for above 5hp motors..

Answer / vinod

IN STAR CONNECTION THE VOLTAGE IS REDUCED TO SQRT(3),SO
THERE IS REDUCTION IN VOLTAGE & PROVIDES SAFE STARTING

Is This Answer Correct ?    10 Yes 1 No

why we used star delta starter for above 5hp motors..

Answer / raj

iT ALSO DEPENDS ON THE SYSTEM FAULT LEVEL OTHERWISE EVERY
ONE USING DOL STARTER.IF THE FAULT LEVEL IS WELL SUFFICIENT
U CAN USE DOL STARTER.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

why 400Hz is used for aircraft systems ?

14 Answers   Cabin Crew, Jet Airways,


how to choose the cable size for 100A(is there any formula please update)

6 Answers  


Why we should not parallel the with EB

1 Answers  


Ceiling fan motor wiring Hi, I have 2 ceiling fans broken. The receiver/control units burned out due to lightening. One Harbor Breeze and one Hunter's I took them apart (remove receiver units). Now on both of the motor I see 4 wires coming out from each motor I really want to know the function of each wire. Are there anyway I can test to see which is which? After searching forums I know these 4 wires are from 2 sets of coils inside the motor, one is Start winding and the other is Runing winding I could not find the receiver/control unit any where, so I am planing to buy Capacitors and universal remote controls to make the fans run again. Anyone has any idea how to do the wiring, please help Thnks

1 Answers  


What is reactance? what is the function in Auto transformer and why high leakage reactance?

1 Answers  






Why cant we connect the motor output to generator and then generator output to motor ?

4 Answers  


how work a harmonics filter(L-C combition).

1 Answers   Bhel,


How to calculate the diesel generator efficiency? what details are required to identify the running diesel generator sets with 1000 kVA & 180 kVA?

11 Answers   Greeves, Sudhir Power,


What size cable is used for HT cable to the transformer of 630kVA, and the supply voltage is 11kV

2 Answers  


what is the difference between neutral

10 Answers  


why shunt capacitor is connected

1 Answers  


last week we did the REF relay test by closing single pole (R phase) of CB and apply 380V at the primary of delta transformer. we get 33A at the primary of the R phase star end. but we get 380A at both R an B in delta side. how and why?

1 Answers   Siemens,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16630)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)