why we used star delta starter for above 5hp motors
Answer Posted / vinod
IN STAR CONNECTION THE VOLTAGE IS REDUCED TO SQRT(3),SO
THERE IS REDUCTION IN VOLTAGE & PROVIDES SAFE STARTING
Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
What are linear and non-linear systems?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
prove that power consumed in 3 phase delta system is 3 times as compared to 3 phase star system
How does cost of generation from hydropower plant compare with other sources of electricity?
Diagram on interconnectivity of 11kv transformer with RMU (i.e, one incoming and two outgoing or two incoming and one outgoing)
What are the basic & Majour problems in UPS ?
What is center gravity load in substation?
operation of protection relay watchdog contact?
what type of motor used to move a 1 ton gate? and relate ratings with load.
What it the purpose of parallel phasing transfomers??
How relay works, reverse relay, master relay, os relay, earth fault relay and what is its setting point
What is the effect on power factor, shown by a trivector meter; incase of reverse phase sequence. If the power factor of a system is lag what meter will show in case of reverse phase sequence connected to the meter. and What in case of lead.
Metal covered multiconductor cables shall employ a marker tape located within the cable running for its complete length in lieu of cable surface marking. Is it true or false?
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????