Interested to Buy Any Domain ? << Click Here >> for more details...
What is infinite Busbar?
- 4 Answers
- 16360 Views
- Equate, I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / vinamra
In a generating station all the genarator is connected with
the common bus ,that bus is known as infinite bus ,Infinite
bus have zero(very low) impedance.
| Is This Answer Correct ? | 16 Yes | 2 No |
Answer / iamdon
Infinite bus bar in power system refers to bus bar which
has infinte inertia.It menas drawing or adding infinte
(practically very large)power does not cause any change in
the voltage and frequency of the bus.
| Is This Answer Correct ? | 11 Yes | 5 No |
Answer / raju
the bus bar which maintains constant frequency and voltage through out the line...here we assume that the moment of inertia of the alternator as infinity...so frequency is independent of small changes in load...
| Is This Answer Correct ? | 5 Yes | 1 No |
Answer / s raghavendra
infinite bus bar is the one where the voltage and frequency of that busbar is independent of changes in load because of connecting all the alternators of all power stations to that line parallel to each other supplies the busbar consant frequency and voltage so that it can withstand very large or infinite load.........................
| Is This Answer Correct ? | 1 Yes | 5 No |
How does frequency affect KVA rating of a transformer? If a 500 kva, 500 to 250 v, 60 hz t/f used in Canada is to be operated on 50 hz in Europe frequency then how will its KVA rating change? a-increase b-decrease c-remains same
What is meant by reverse polarity and how it can be fixed?
What is Tachometer used to measure?
1.What is the maximum transmission voltage in india & where it is located? 2.more information about indian power scenario.
please explain how to do 'pole drop test' on generator?
cable armor
Why two main buses and one transfer bus scheme not using for 400kV switchyard
What is Earth Fault and Over current Fault.
what is two point starter?
how can we can take BDV test in transformer?
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
Why we use cosine angle for calculating power factor not in sine angle ?
-
Civil Engineering (5086) - Mechanical Engineering (4453)
- Electrical Engineering (16638)
- Electronics Communications (3918)
- Chemical Engineering (1095)
- Aeronautical Engineering (239)
- Bio Engineering (96)
- Metallurgy (361)
- Industrial Engineering (259)
- Instrumentation (3014)
- Automobile Engineering (332)
- Mechatronics Engineering (97)
- Marine Engineering (124)
- Power Plant Engineering (172)
- Textile Engineering (575)
- Production Engineering (25)
- Satellite Systems Engineering (106)
- Engineering AllOther (1379)
