what is back emf?
Answers were Sorted based on User's Feedback
Answer / sumit
since the induced emf in the dc motor oppose the votage
applied to the armature of a dc motor. so it is called the
back emf
Is This Answer Correct ? | 7 Yes | 0 No |
Answer / vishnu gandhi
All windings have self inductance and mutual inductance. So
Lx dI/dt effect produces oppose to current which can be
termed as back emf. In case of Induction Motor the rotor
is short cicuited secondary of transformer which produces
it's own magnetic field and back emf is iduced in primary
winding which depend upon speed of rotor and
current.
Is This Answer Correct ? | 3 Yes | 1 No |
Answer / dhaval busa
we take dc motor,when we apply voltage in dc motor the current is flow.the armature carrying conductor take current and cut the main field. according to faraday's law rate of change of flux,emf is induced but oppose the emf according to lenz's law.this emf called back emf
Is This Answer Correct ? | 0 Yes | 0 No |
Answer / sathish
An EMF which comes backwards is called bach emf
Is This Answer Correct ? | 0 Yes | 9 No |
why in three phase 440 circuit in all phase current is almost equal L1-35 A,L2-34 A ,L3-31 A but in nutral when i check with clamp meter it shows 25 A?
In DC generator, we use commutator, having no. of segments. Then how it is possible to get a half wave of voltage and current for half rotation of armature?
what is diffrence between neutral and earth wire
23 Answers Bhel, Esab, MTNL,
how tto ingress mw in turbine explain.procedure ?
whatis the commertial spec. of distribution boards ?
IN MY SYSTEM THERE IS ONLY OVER CURRENT EARTH FAULT RELAY IS AVAILABLE. FOR THE UNBALANCE SENSING IS THERE ANY RELAY IS AVAILABLE? THE SAME CTs WHICH ARE USED FOR THE OVER CURRENT EARTH FAULT RELAY CAN USE FOR UNBALANCE ALSO?
what is starting current and use of starting current?
how power can be saved using VFDs in detail explain
WHY IN THREE PHASE CABLE 440V CURRENT FLOWS IF IN ONE PHASE 230V CURRENT FLOWS ???
I am getting differential earth fault in my transformer realy , i have checked all its CT & control wiring but do not get fault, Please help
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
What is the meaning of 'A synchronous motor floating on line'?