WHY LATCHING CURRENT IS GREATER THATN HOLDING CURRENT?
The coil used for latching has to exert more force to pull or
push the latch and it gets momentarily energized.
| Is This Answer Correct ? | 2 Yes | 3 No |
What are motor generator sets and explain the different ways the motor generator set can be used ?
Is it recommended to apply H.pot test for new cables segments after terminations or joints, however, this cable has been tested before at the manufactor by the vendor ? or only we can apply megger tests ?
What is the use of oil in transformers?
How to decide no. of Step and Kvar for APFC Panel 40 kvar MD: 33.12 KVA Avg pf : 0.8540
please give me all the Alarm .Trip ,Safety Relays & Conditions of Chiller mail me on ashokbabunhce@gmail.com
What will happen if i used 11KV earth ht kit to 11 KV / 11 KV cable termination?
Why the output of generator varies eventhough the shaft speed is constant in thermal power plant?
what is meant by LT & HT?
3 ph motor connected in star delta starter. when we start the motor it run in star but when in is going in delta it trips the main incoming supply. why?
Why Earthin is not required in Xformer primary side when it is in Star / star?
what is positive , negative & zero equivalent system resistance
what is GRR(Grid Rotot resistance)?Why it is used beside of LRS?
9 Answers ACC, L&T, Sri Biotech,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)