Interested to Buy Any Domain ? << Click Here >> for more details...
WHY LATCHING CURRENT IS GREATER THATN HOLDING CURRENT?
- 1 Answers
- 8007 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The coil used for latching has to exert more force to pull or
push the latch and it gets momentarily energized.
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
What happens if we run alternator on under frequency?
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
Why does inductive loads consume KVARs?
How i can decide that HVDC line is best for transmission.
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
how to calculate the magnetizing current of ct ( 800A/1A) for Relay 64
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
what is the difference between electrical and electronic choke?
Draw the vector diagram and condition for the following: 1) Dyn1 2) Ynd0 3) YnYn0
Determine the BTU size of an aircon for 20 sq metre room
how to calculate compresor capacity?
what is the difference between gas group b and gas group c electrical equipment construction wise?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
why impudance relay used for medium transmission power system? why not others?
