WHY CFL can't made in shape of bulb.
Answers were Sorted based on User's Feedback
Answer / amit kumar sharma
The gas present inside the cfl tube is charged through
igniter. The gas being pressurised gets charged when
uniformly distrubuted. As bulb is not a uniform shape of
container it can not be charged to lighting.
Is This Answer Correct ? | 33 Yes | 2 No |
Answer / ramesh
Sorry for above reply
Each particle are ionized inside the tube get lux
illumination, this illumination are more sharper in small
tube with low pressure ,so that CFL are not shaped as
general lamps. The inner circuit are design with low power
factor for reduce electric bill-- RAMESH
Is This Answer Correct ? | 1 Yes | 1 No |
Answer / ramesh
Each particle are ionized inside the CFL tube get lux
illumination, this illumination are more sharper in small
tube with low pressure ,so that CFL are shaped as general
lamps. The inner circuit are design very low power factor
for reduce electric bill-- RAMESH
Is This Answer Correct ? | 0 Yes | 1 No |
what is a speed of rotor when we give supply to stator of 50hz and as well as rotor of 60hz of an induction motor?????
how many test is necessary for 27mva transformer.
which connection is there in a rotor of the motor
2 Answers All Trades Electrical, HAL,
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
testing ZNYn11(d) vector group transformer
1- What is the Polarization Index number be good for 15KV 3c#500MCM electrical cable? 2- Can I use the IEEE Std 43-2000 to perfom the PI test? Thanks
which is more danjerous high voltage or high current
if single phase is having 220v supply then why three phase is having 440v instead of 660v?
HOW TO CALICULATE THE LEAD ACID BATTERY AH AND HOW TO FIND THE 1.2KVA UPS BACKUP @ 1000WATTS LOAD?
why secondary terminal of current transformer should not be open circuited?
our company have 750 kva oil transformer.still we have facing a problem that is when voltage is 11.5 kv coming from HT side then LT-side voltage is 420v or above at tape 1.please give me best solution to decrease the voltage.
What are applications of Shunt release?
2 Answers Techno Electric and Engineering,