Answer / amsal

simulation means (The act of giving a false appearance of input or signal)
to our system so that we can check our loop, response of relative outputs, to bypass the protection,
For example
1.to check smoke, heat detectors response we apply magnet to activate its relay to energize a false fire signal to system.
2.to check our loop during commissioning we apply mAs and get values in CCR.
3.whenever such situation has to face that an erratic signal persisting protection and machine cannot start so we can apply necessary pulse to our logic and start our machine.

Answer / ajay bhalerao(instrumentation

simulation is tools for giving false appereance at input

for checking logic result

by simulation we can check stroke (operation) of control
valves,control test of motor(start/stop),

and major advantage is ,during plant running,if any input
not working properly,then by simulating we can rectify its
problem in such way we can avoid the false tripping of plant

Answer / roshan

simulation is used whenever we do not use the kits in theplcs ,we hav the inbuilt feature in our pc itself called simulation

An electronic p controller has an input range of 1-5v, and output range of 4-20mA, while testing a step change of 0.4 was applied at the input , the PB setting was 50% ,what should be the change in the output ?

1 Answers   Reliance,

---

what is the approximate cost of U tube manometer having range 1000mmwc to 1000mmwc?

1 Answers  

---

what is the procedure to isolate flow a transmitter and flushing it?

8 Answers   Petrofac,

---

Steve said that "An eddy-current probe works by passing an alternating current through a coil of wire and measuring the coil’s impedance" while we are using -24 Volt DC , So I am confused about DC and AC. Plz .

2 Answers   Jindal, Sadara Chemicals,

---

why we connect digital multimeter in series for dc current measurement and parallel for dc voltage measurement.

4 Answers  

---

Is there any interfacing sofware to build communication between a PC and ER300P model L&T make trivector meter via RS485 port which is available in the meter and is there any data acquisition card available to store the acquired data from the meter into the system

12 Answers  

---

In control valve , Failure position : Close If it is Fail close(FC) during failure of AIR.. what will be the initial/ normal position of control valve is it normally open or close? please some one explain soon..

2 Answers  

---

if i change range of flow transmitter in th field then does it need to change range in dcs?

3 Answers  

---

How a oxygen sensor & analyzer work at boiler or furnace, what’s the principle & science is beyond this, How O2 sensor scene & convert signal & move toward analyzer & analyzer show reading in percent?

1 Answers   GS Engineering Construction, KNIC,

---

what is the difference between Feedback controller and Feed forward controller. and when it is to be used.

3 Answers  

---

whats the abbreviation of IOP? is it instrument of power or input open problem?

0 Answers  

---

What is the difference between ff transmitter and non ff transmitter

0 Answers   Samsung,

---